Current Position:首页 > Products > Pre-processing

Flatbed dryer

TIME:2014-12-08 10:29:13FROM: AUTHOR:
Flatbed dryer, germ oil pretreated material made of oil, depending on the process, some used as press or pre-press, while others are used for direct leaching.
F...

Flatbed dryer, germ oil pretreated material made of oil, depending on the process, some used as press or pre-press, while others are used for direct leaching.
For direct leaching parison, preprocessing needs to be processed at a later stage by the drying process. In addition to vertical steaming wok drying equipment can be used outside, as well as specialized drying equipment. The following describes a grease factory more common chain steam dryer, also known as flat pull dryer.
Flatbed dryer from the rack, heating plate, retaining plate, tensioning device, hopper, moisture row cover, intake manifold, condensate discharge pipe, transmission, doors and other components were observed.

               Flatbed dryer
Transmission process transmission mechanism, motor driven reducer, reducer output shaft driven bottom of the chain axis, the central axis of the shaft driven by sprocket chain, the central axis of the upper part of the shaft and then drive. Into the hopper feed roller driven by the reducer output shaft.
When the tablet dryer work, which leads to a heated piece 0.5MPa steam (or thermal oil), raw green sheet from the feed hopper, falling in the first layer is heated sheet ends, with the scraper dragged accepted during heating. Parison run to the end of the first layer, that fall on the second floor heating film, returns tow line continues to be heated. When you run to the end of the second layer, third layer of material falling into the embryo and then heating the film, so, one after another through the fourth, fifth and six pieces of the heating treatment. Finally, the parison falls after the drying process at the outlet of the screw conveyor, is fed out of the machine.
Trailer containing material back and forth carrying embryos scraper chain, no-load. Layers bake out of the water, the upper part of the exhaust hood exhaust import. Embryo material after drying, generally reduce the water 4 percentage points.


PRE:Drying
NEXT:返回列表