Current Position:首页 > Technology

Exclude the press clogged method

TIME:2014-11-17 08:53:29FROM: AUTHOR:
Exclude the press clogged method after oil extraction machinery and household equipment in a variety of combinations of the Department of sets of mechanical fai
       

Exclude the press clogged method after oil extraction machinery and household equipment in a variety of combinations of the Department of sets of mechanical failure, according to the following measures:
1, screen cloth oil go unilateral. Check, if the case of a lateral screen surface is not level, adjust the length of the boom about to make it equal; if they are sieve appear Wiggler, adjustable eccentric axle so that the vertical rack. If you belong to the stone screen surface oil to go unilateral, the adjustable rack horizontal; if they are uneven airflow, adjustable wind deflector tune the bellows so that the air flow blows the screen surface evenly. If it is the sieve net rate, should be replaced with a new brush or brush length adjustment, and adjust the tilt angle of the flat screen.
2, not to mention the belt Dayou material. The main reason is that the bucket elevator conveyor lower part of the excessive accumulation of oil, causing blockage, the lower part of the conveyor can open doors, remove accumulated oil can.
3, the pot steaming blank uneven. Check, if the case of jet vapor steaming machine clogging or corrosion, should clear the jet steam holes. If it is the blank in the paste pot under the pot, adjust the distance between the blade and the bottom of the pot; if they are worn twisted blade, the blade should be replaced; if they are steamed fried dough raw and cooked unevenly, adjust limit switches, contacts and kickboard, so motor coordination.
4. Roll overload does not rotate. Remedy is: if oil roll between the rollers, roller adjustment bolts can loosen, remove fuel between the rollers when you start; if they are feeding too large too fast, you can turn off the feed opening of the flapper; if they are rolled a blank uneven thickness, should be re-adjust the roll gap, tightening loose nuts.